20 www.SimplicityMfg.com | www.MasseyLawn.com | www.AGCOLawn.com | www.Snapper.com

Normal Remocal & Installation

Normal Removal & Installation
Figure 36. Install Turbo Blower
A. Pivot Pin
B. Deflector
C. Turbo
D. Anchor Bracket
E. Wingnut
F. Pivot Bracket
Figure 37. Turbo Belt Routing
A. Turbo Drive Belt
B. Mower Deck Drive Pulley
C. Belt Tension Lever
D. Idler Pulleys
E. Mower Deck Turbo Drive Pulley
F. Turbo Drive Pulley
D
C
E
B

Turbo & Tube Installation

Note: The grass catcher hitch, channel and cover
must be installed according to the Catcher Operator’s
Manual before proceeding with the next steps.
1. Place the mower deck in the highest cut position.
2. Slide the pivot pin (A, Figure 36) into pivot bracket
(F).
3. Raise the deflector (B).
4. Rotate the turbo (C) and “latch” the slot in the
turbo housing over and onto the anchor bracket
(D). Tighten the wingnut (E) to secure turbo (C).
5. Pull back (away from deck) on belt tension lever
(C, Figure 37).
6. Install the turbo drive belt on pulleys as shown and
release the belt tension lever (C).
7. Follow the Bagger Operator’s Manual for
installation of catcher components.
8. Slide the discharge end of tube assembly (A,
Figure 30) through the seal (A). This may require
some rotating or turning of the discharge end of
tube assembly.
9. Slide the intake end of tube assembly (E) over the
turbo aligning clip (C) and nut and capscrew (D).
10.Lift clip (C) over nut and capscrew (D) to secure
tube to turbo.
A
F
B
E
C
F
D
A
CAUTION
Before you begin operating the unit with the
Turbo attached, be certain you have read all of
the safety information in this Operator’s
Manual, as well as the Operator’s Manual for
the tractor and any grass catchers or other
collection devices used in conjunction with
this turbo blower.