17
Assembly
Figure 28. Install Deflector Plate
A. Deflector Plate
B. Cover
C. New 7/32” Holes
D. Screws, #10-24 x 3/4
E. Locknuts, #10-24
A
D
A
C
C
E
E
D
B
C
A
Figure 29. Install Thick Seal
A. Thick Seal
B. Corner, LH
C. Hinge Edge
B
Triple Collector - Plate and Edging
1. Hold deflector plate (A, Figure 28) in cover (B) as
shown and mark new hole locations using
deflector plate holes as a guide.
2. Drill two 7/32” holes in the locations marked in the
previous step.
3. Secure deflector plate (A) to cover (B) using #10-
24 x 3/4 screws (D) and #10-24 locknuts (E).
4. From the inside of grass catcher slide the thick
seal (A, Figure 29) starting at the LH side of the
hinge edge (C) to the corner (B) on the cover edge
as shown.
Twin Collectors - Edging
1. From the inside of grass catcher slide the thin seal
(A, Figure 30) onto the cover edge (B) starting at
the LH side of the hinge edge (D) so that the
inside curl (C) is toward the inside of the cover .
2. From the inside of grass catcher slide the thick
seal (A, Figure 5) on the cover edge as shown
starting at the out side end of the thin seal (B) and
continuing around the cover.
Figure 30. Install Thin Edging
A. Thin Edging
B. Cover Edge, LH
C. Inside Curl
D. Hinge Edge
A
B
D
C