ACCESSORIES

Recommended accessories for use with our pressure washer are available for purchase from your local retailer or authorized service center. if you need assistance in locating any accessory for your pressure washer, please go to www.power-washer.us

Risk of fl uid injection. When using replacement lances or guns with this pres- sure washer, DO NOT use a lance and/or lance/gun combination that is shorter in length than what was provided with this pressure washer as measured from the nozzle end of the lance to the gun trigger.

The use of any other accessory not recommended for use with this tool could be haz- ardous. use only accessories rated equal to or greater than the rating of the pressure washer.

TROUBLE SHOOTING GUIDE

PROBLEM

CAUSE

CORRECTION

Engine will not

No Fuel

Add fuel.

start (see Engine

 

 

Pressure builds up after two pulls on

Squeeze gun trigger to relieve pres-

manual for further

the recoil starter or after initial use.

sure.

troubleshooting).

 

 

Choke level in the “No Choke” position.

Move choke to the “CHOKE” position.

 

 

 

 

 

Spark plug wire not attached.

Attach spark plug wire.

 

 

 

 

Engine Switch in the “OFF” Position.

Place engine switch in “ON” Position.

 

 

 

 

Choke lever in the “CHOKE” position

Move choke to the “NO CHOKE” posi-

 

on a “hot” engine or an engine that has

tion.

 

been exposed to thermal heat for a

 

 

long period of time.

 

No or low pressure

Variable Spray Wand not in High Pres-

See How to Use Spray Wand instruc-

(initial use).

sure Position.

tions.

 

 

 

 

Low Water Supply.

Water Supply must be at least 5 GPM

 

 

and 20 PSI.

 

 

 

 

Leak at high pressure hose fi tting.

Repair Leak. Apply sealant tape if

 

 

necessary.

 

 

 

 

Nozzle Obstructed.

See Nozzle Cleaning instructions.

 

 

 

 

Water Filter Screen Clogged.

Remove and clean fi lter.

 

 

 

 

Air in hose.

Turn off the engine, then the water

 

 

source. Disconnect the water source

 

 

from the pump inlet and turn the water

 

 

source on to remove all the air from the

 

 

hose. When a steady stream of water

 

 

is present, turn the water source off.

Continued on next

 

Re-connect water source to pump inlet

 

and turn on water source. Squeeze

page.

 

 

trigger to remove remaining air.

 

 

16

Page 16
Image 16
Simpson V3100 warranty Accessories, Trouble Shooting Guide