CLEAN THE WATER INLET FILTER

Filter Screen

This screen fi lter should be checked periodically and cleaned if necessary.

1)Remove fi lter by grasping end and removing it from water inlet of pump.

2)Clean fi lter by fl ushing it with water on both sides.

3)Re-insert fi lter into water inlet of pump.

NOTE: Do not operate the pressure washer without fi lter properly installed.

STORAGE

ENGINE

Consult the Engine Owners Manual for manufacturer’s recommendations for storage.

PUMP

The manufacturer recommends using a pump protector/winterizer when storing the unit for more than 30 days and/or when freezing temperatures are expected. Pump protector/winterizer is usually avail- able at the store where the pressure washer was purchased. If a pump protector/winterizer is not available, RV antifreeze needs to be run through the pump as outlined in the steps below.

NOTE: Using a pump protector/winterizer or RV antifreeze is to provide proper lubrication to the inter- nal seals of the pump regardless of temperature or environment.

1)Obtain a funnel, 6 ounces (170 mL) of RV Antifreeze, and a 16” to 36” (40-91cm) section of garden hose with a male hose connector attached to one end.

Risk of Property Damage. Use only RV Antifreeze. Any other antifreeze is corrosive and can damage the pump.

2)Disconnect the spark plug wire.

3)Connect the length of garden hose to the water inlet of the pump.

4)Add RV Antifreeze to hose as shown.

5)Pull starter rope slowly several times until antifreeze comes out of the high pressure hose connection of the pump.

6)Remove garden hose from water inlet of pump.

7)Reconnect spark plug wire.

PRESSURE WASHER

1)Drain all water from high pressure hose, coil it, and store it in cradle of the pressure washer handle.

2)Drain all water from the spray gun and wand by holding spray gun in a vertical position with nozzle end pointing down and squeezing trigger. Store in gun holder.

3)Store chemical hose, if so equipped, so it is protected from damage.

REPAIRS

To assure product SAFETY and RELIABILITY, repairs, maintenance, and adjustment should be per- formed by an Authorized Warranty Service Center. Always use identical replacement parts. For the location of the nearest Authorized Service Center go to www.power-washer.us

15

Page 15
Image 15
Simpson V3100 warranty Storage, Repairs, Clean the Water Inlet Filter, Engine Pump, Pressure Washer