Adjustments
Blade 45° To The Table
FIG. 8
1.Rotate table 1 to 0° position and lock in place.
2.Move sliding fence to its proper position. (See Sliding
Fence on page 50.)
3. Lower head assembly. Lock in place.
4. Loosen bevel lock handle 4 and tilt the head assembly to 45° bevel. Check the 45° bevel stop. The bevel indicator should be on the 45° mark, the 45° bevel stop should be in full contact with the 45° bevel stop screw, and the blade 2 should contact the full length of the combination square 3 (Figure 8).
5. If the blade is not 45° with the table, adjust 45° bevel stop.
45° Blade Alignment
a.Move sliding fence to proper position. (See Sliding Fence on page 50.)
b.Loosen bevel lock handle 4 (Figure 9).
2
3 1
c. Bevel the head assembly to 0° to access the adjustment screw 5.
FIG. 9
d. Using the small hex wrench located behind the sliding fence, adjust the screw 5 up or down.
e. Move the head assembly back to 45° and
f. Repeat if necessary.
g. Check that bevel indicator is pointing to the 45° mark on the bevel scale (see Figure 8). If bevel indicator is not aligned with the 45° mark, first recheck the blade squareness to the table and 0° bevel indicator alignment. Then, repeat the 45° blade alignment and make appropriate adjustments.
4
º 0
º 5 1
º 0 3
º 5 4
5
36
