Saw Operations

Crown Molding Laying Flat on Table

Follow these instructions for cutting crown molding:

1.Move sliding fence to proper position (see Sliding Fence on page 50).

2.Set the bevel and miter angles using Chart 1 below. Tighten the miter lock knob and the bevel lock handle (Figure 31).

3.Position molding on saw table. Use the chart below for correct position. Clamp workpiece in place using the vertical clamp.

!WARNING Use clamping position that does not interfere with operation. Before switching

on, lower head assembly to make sure clamp clears guard and head assembly.

4.Activate the switch. Lower the head assembly and make your cut.

5.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.

6.ALWAYS TAKE A TEST CUT USING SCRAP TO CONFIRM CORRECT ANGLES.

FIG. 31

Sliding

Fence

Crown

Molding

33.9°

Bevel

Vertical

Clamp

31.6°

Miter

MAXIMUM

SIZE 4-1/2"

Chart 1: Crown Molding Flat on Table

62

Page 62
Image 62
Skil 3800 manual Crown Molding Laying Flat on Table, Size 4-1/2, Sliding Fence Crown Molding 33.9, Vertical Clamp 31.6