SMC Networks SMC6752AL2 manual Enabling Lacp on Selected Ports Command Usage, 166

CONFIGURING THE SWITCH

CLI – This example creates trunk 2 with ports 1 and 2. Just connect these ports to two static trunk ports on another switch to form a trunk.

Console(config)#interface	port-channel 2	4-145
Console(config-if)#exit
Console(config)#interface	ethernet 1/1	4-145
Console(config-if)#channel-group 2		4-166
Console(config-if)#exit
Console(config)#interface	ethernet 1/2
Console(config-if)#channel-group 2
Console(config-if)#end
Console#show interfaces status port-channel 2		4-153
Information of Trunk 2
Basic information:
Port type:	100TX
Mac address:	00-00-E8-AA-AA-01
Configuration:
Name:
Port admin:	Up
Speed-duplex:	Auto
Capabilities:	10half, 10full, 100half, 100full
Flow control:	Disabled
Port security:	Disabled
Max MAC count:	0
Current status:
Created by:	User
Link status:	Up
Port operation status:	Up
Operation speed-duplex:	100full
Flow control type:	None

Member Ports: Eth1/1, Eth1/2,

Console#

Enabling LACP on Selected Ports

Command Usage

•To avoid creating a loop in the network, be sure you enable LACP before connecting the ports, and also disconnect the ports before disabling LACP.

•If the target switch has also enabled LACP on the connected ports, the trunk will be activated automatically.

	dynamically
	enabled
	}
active	backup
links	link
	}
	configured
	members

3-96