SMC Networks SMC6752AL2 manual Rate Limit Commands

COMMAND LINE INTERFACE

Example

The following shows mirroring configured from port 6 to port 11:

Console(config)#interface ethernet 1/11 Console(config-if)#port monitor ethernet 1/6 rx Console(config-if)#end

Console#show port monitor Port Mirroring

-------------------------------------

Destination port(listen port):Eth1/11

Source port(monitored port)	:Eth1/ 6
Mode	:RX
Console#

Rate Limit Commands

This function allows the network manager to control the maximum rate for traffic transmitted or received on an interface. Rate limiting is configured on interfaces at the edge of a network to limit traffic into or out of the network. Traffic that falls within the rate limit is transmitted, while packets that exceed the acceptable amount of traffic are dropped.

Rate limiting can be applied to individual ports or trunks. When an interface is configured with this feature, the traffic rate will be monitored by the hardware to verify conformity. Non-conforming traffic is dropped, conforming traffic is forwarded without any changes.

Note: The “rate limit granularity” is multiplied by the “rate limit” (page 4-161)to set the actual rate limit for an interface. Granularity is a global setting that applies to Fast Ethernet or Gigabit Ethernet interfaces.

Table 4-43 Rate Limit Commands

Command	Function	Mode	Page
rate-limit	Configures the maximum input or output	IC	4-161
	rate for a port
rate-limit	Sets the Fast Ethernet and Gigabit Ethernet	IC	4-162
granularity	granularity
show rate-limit	Shows the rate limit granularity	PE	4-163

4-160