SETUP WIZARD
Parameter Setting
Select your Country and Internet Service Provider. This will automatically configure the Barricade with the correct Protocol, Encapsulation and VPI/VCI settings for your ISP.
If your ISP uses Protocols PPPoA or PPPoE you will need to enter the username and password supplied by your ISP.
If your ISP uses Protocol RFC1483 Routed you will need to enter the IP address, Subnet Mask, and Default Gateway supplied by your ISP.
If your Country or Internet Service Provider is not listed in this screen, you will need to manually enter settings. Go to “Parameter Setting - Country or ISP Not Listed” on page
Note: If your ISP has not provided you with a DNS address and the protocol is PPPoA, PPPoE or 1483 Bridging, you can leave this field blank. The Barricade will then automatically obtain the DNS address.
Click NEXT to continue.
