SMC Networks SMC790WBRA4

Click Apply Changes to save the settings of this page.

3.7.8.2 UPNP

Choose UPNP in the left pane. The page shown in the following figure appears. This page is used to configure

UPnP. The system acts as a daemon after you enable it.

Click Apply Changes to save the settings of this page.

3.7.8.3 Bridge

Choose Bridge in the left pane. The page shown in the following figure appears. This page is used to configure the

bridge parameters. In this page, you can change the settings or view some information in the bridge mode and its

attached ports.

46

Contents

Main Contents Page 1 Introduction 1.1 Packing List 1.2 Safety Cautions 1.3 LED and Interface Front panel The following table describes the LEDs of the device. Rear panel The following table describes the interfaces of the device. 1.4 System Requirements 1.5 Features Page 2 Hardware Installation Connection 1 Connection 2 Page 3 About the Web Configuration 3.1 How to Access the Router 3.2 Setup Wizard Page Page PPPoE Page Dynamic IP Static IP Bridge Page Page 3.3 Status 3.3.1 3.3.2 Page 3.3.5 3.3.6 3.3.6.1 Traffic Statistic 3.3.6.2 DSL Statistic 3.3.7 3.4 LAN 3.4.1 3.4.2 Page Page 3.5 WLAN 3.5.1 3.5.2 The following table describes the parameters and buttons of this page. Click Set WEP Key, the page shown in the following figure appears. 3.5.3 3.5.4 3.5.5 3.6 WAN 3.6.1 The following table describes the parameters of this page. Page 3.6.2 3.7 Advance 3.7.1 3.7.1.1 DNS Server 3.7.1.2 DDNS 3.7.2 3.7.2.1 IP/Port Filter 3.7.2.2 MAC Filter 3.7.2.3 URL Blocking 3.7.3 3.7.3.1 Services 3.7.3.2 DMZ Settings 3.7.4 3.7.4.1 Static Route 3.7.4.2 RIP 3.7.5 3.7.6 3.7.7 3.7.8 3.7.8.1 IGMP Proxy Page 3.7.8.4 IP PassThrough 3.8 Admin 3.8.1 3.8.2 3.8.3 3.8.4 3.8.5 3.8.6 3.8.7 3.8.8 3.8.9 3.8.10 3.9 Diagnostic 3.9.1 3.9.2 3.9.3 Page Appendix A Questions & Answers Page Appendix B Technical Specifications External Connectors Protocol Feature ADSL Feature Ethernet Feature Management Support Security Support Environment Appendix C GPL Anouncement Preamble