SMC Networks SMC790WBRA4 3.9.1

Step 1 Select Enable and click take effect.

Step 2 Configure the ACL.

Step 3 Click take effect to take the configuration effect.

I Note:

If you select Enable in ACL Capability, ensure that your host IP address is in ACL list before it takes effect.

In the navigation bar, choose Diagnostic. The Diagnostic page that is displayed contains Ping, ATM Loopback,

ADSL, and Diagnostic.

3.9.1 Ping

Choose Diagnostic > Ping. The page shown in the following figure appears.

The following table describes the parameters and buttons in this page.

55

Contents

Main Contents Page 1 Introduction 1.1 Packing List 1.2 Safety Cautions 1.3 LED and Interface Front panel The following table describes the LEDs of the device. Rear panel The following table describes the interfaces of the device. 1.4 System Requirements 1.5 Features Page 2 Hardware Installation Connection 1 Connection 2 Page 3 About the Web Configuration 3.1 How to Access the Router 3.2 Setup Wizard Page Page PPPoE Page Dynamic IP Static IP Bridge Page Page 3.3 Status 3.3.1 3.3.2 Page 3.3.5 3.3.6 3.3.6.1 Traffic Statistic 3.3.6.2 DSL Statistic 3.3.7 3.4 LAN 3.4.1 3.4.2 Page Page 3.5 WLAN 3.5.1 3.5.2 The following table describes the parameters and buttons of this page. Click Set WEP Key, the page shown in the following figure appears. 3.5.3 3.5.4 3.5.5 3.6 WAN 3.6.1 The following table describes the parameters of this page. Page 3.6.2 3.7 Advance 3.7.1 3.7.1.1 DNS Server 3.7.1.2 DDNS 3.7.2 3.7.2.1 IP/Port Filter 3.7.2.2 MAC Filter 3.7.2.3 URL Blocking 3.7.3 3.7.3.1 Services 3.7.3.2 DMZ Settings 3.7.4 3.7.4.1 Static Route 3.7.4.2 RIP 3.7.5 3.7.6 3.7.7 3.7.8 3.7.8.1 IGMP Proxy Page 3.7.8.4 IP PassThrough 3.8 Admin 3.8.1 3.8.2 3.8.3 3.8.4 3.8.5 3.8.6 3.8.7 3.8.8 3.8.9 3.8.10 3.9 Diagnostic 3.9.1 3.9.2 3.9.3 Page Appendix A Questions & Answers Page Appendix B Technical Specifications External Connectors Protocol Feature ADSL Feature Ethernet Feature Management Support Security Support Environment Appendix C GPL Anouncement Preamble