System Requirements
Before you install the EZ Card 1000, check your system for the following requirements:
•A PC and BIOS that support the PCI Local Bus Specification v2.0 or later
•An available
•Category 5 or 5e UTP cable with
•An IEEE
Note: If you are installing in an older PC model (Pentium or earlier), upgrade the BIOS to the latest version.
Hardware Installation
WARNINGS:
•This network adapter requires a PC and BIOS that support the PCI Local Bus Specification v2.0 or later. If you are installing in an older PC model, upgrade the BIOS to the latest version.
•Network cards are sensitive to static electricity. To protect the card, avoid touching its electrical components and always touch the metal chassis of your computer before handling the card.
1.Switch off the computer, unplug the power cord, and remove the computer’s cover.
2.Select an available PCI slot and remove the cover bracket.
-When using a
3.Install the network card into the slot so that it is firmly seated. Then screw the card’s bracket securely into the PC’s chassis.
4.Replace the chassis cover and power up your PC.
5.The EZ Card 1000 should be automatically configured by the host computer’s BIOS. However, if you have an older computer, you may have to manually configure the computer’s BIOS settings (see “Troubleshooting”).
6.The Driver & Documentation CD that accompanies the EZ Card 1000 contains all the network operating system drivers supported by this card. Please read the “RELEASE.TXT” file on the CD for a list of all drivers. Refer to following sections on this manual for instructions on installing drivers. Any new or updated drivers can be downloaded from SMC’s Web site (WWW.SMC.COM).
8
