Smeg A2EA manual Use Of The Ovens, Warnings and general advice, Oven Light, Cooling fan

Instructions for the user

7. USE OF THE OVENS

7.1 Warnings and general advice

Before using the oven for the first time, pre-heat it to maximum temperature (250°C) long enough to burn any manufacturing oily residues which could give the food a bad taste.

Before using the oven for the first time, pre-heat it to maximum temperature (250°C) long enough to burn any manufacturing oily residues which could give the food a bad taste.

After a power failure, the display will flash at regular intervals showing

. To regulate, refer to paragraph "5.2 Electronic Programmer”.

During cooking, do not cover the bottom of the oven with aluminium or tin foil and do not place pans or oven trays on it as this may damage the enamel coating. If you wish to use greaseproof paper, place it so that it will not interfere with the hot air circulation inside the oven.

To prevent any steam in the oven creating problems, open the door in two stages: half open (5 cm approx.) for 4-5 seconds and then fully open. To access food, always leave the door open as short a time as possible to prevent the temperature in the oven from falling and ruining the food.

7.2 Oven Light

It comes on when the function switch knob is turned to any position.

7.3 Cooling fan

The appliance is equipped with a cooling system which comes into operation regardless of the cooking function selected, including the automatic cooking function.

The fan, installed in the rear of the appliance, drives the air across the top of the oven and through the vent slits above the door.

The noise caused by the air flow will continue even after the oven is switched off.

The cooling system ensures that the temperature on the outside of the appliance complies with the parameters required by the European Standard.

19