Setting the temperature | Alliance Laundry Systems CI 1650/325

5

Setting the temperature

The ironing temperature of the machine can be set on the control panel. Standard, this can vary between 130 and 175°C and is adjustable per degree. The range of the temperature setting can be changed in the technical menu of the machine. This is shown on the left window of the control panel (see 7 on the picture below).

Advice

At the first start up of the ironer, set the ironing temperature to max. 160°C. When start ironing, increase the temperature to the desired level.

The temperature can be changed as follows:

Press the “–“ key (5) to enter the temperature window (7). With the “+” (4) and “–“ (5) key, you can set the temperature. Press the ↓ key (6) to leave the menu.

WARNING

Always watch the temperature setting when different sorts of textile are being processed. The temperature may not be too high, otherwise the textile could catch fire.

Important

If you have set a new temperature that is lower than the actual ironing roller temperature of the machine, you have to take into account that it may take some time before the ironing roller has cooled down to the lower (set) temperature.

34

Image 34

Alliance Laundry Systems CI 1650/325, CI 2050/325 instruction manual Setting the temperature, Advice

Contents

Part No. D1273 SeptemberPage Contents Safety Information Explanation of Safety MessagesPage Safety notice Important Safety Instructions Page Product description Intended use Description of structural components Workplaces and noise level Technical data CI1650/325, CI2050/325 1650/325 2050/325 Sound level measurement Warranty and service instructions Initial setup of the machine Transport and machine fastening Setting up the machine 30 cmPage Page Page 16A Page Basic checks Ventilation of the room Air filters Exhaust gases Operation Operating devices and their position Starting the machine Set the ironing speed Set the iron temperatureFunctions Pedal Return button not with guiding ribbons Ending Failure and information signals Page Page Page General description of machine function Machine function, adjustment and troubleshootingDescription of machine functions Feeding sheets and towels Operating the foot pedal option Setting the temperature Advice Setting the speed Manual drive Adjustments of the machine Guiding ironing belts Tightening the drive chain Tightening the ironing belts Tightening the feeding belts Adjusting the gap between input table and main roll Fault Cause Remedy TroubleshootingFault Condition Possible cause After reset Fault Condition Solution General description of the control system Temperature controlDescription of the control system Electric heating control Speed control Control of exhaust ventilatorStart/stop function Control panel and function keys Menu structure and how to enter Manual version Menu structure Manu adjusting menu Coin adjusting menu C1H coin 1 High Add XX defaultC1M coin 1 Medium C2L coin 2 low Technical menu Ki Xxxx default gas 0.5 default elec Kp Xxxx default gas 300 default elecKd Xxxx default gas 1000 default elec Start PWM default REv Y/n default YES not adjustable with coin TMP Sigma explorer Display menuCentral panel DiSP Maintenance scheme MaintenanceSafety advice Daily maintenance Weekly maintenance Monthly maintenancePage Page Half-yearly maintenance Feeding belts Ironer belts Drive Scrapers