Instructions for the installer
2.INSTALLATION OF THE APPLIANCE
It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990.
It can be placed against walls higher than the hob, at a distance of at least 50 mm from the side of the appliance, as shown in the drawings A and B relating to the installation classes. Wall units or extractor hoods located above the hob must be at least 750 mm away from it.
A 
B
SLOT IN | FREE STANDING |
2.1 Positioning and levelling of the appliance
This appliance is fitted with 4 castors for easy positioning. To block the appliance in tis final position, extract the feet on the front and screw the corresponding castors in.
CAUTION: delicate floors could be damaged by the castors; in this case, lift the appliance with a mechanical means.
2.2 Electrical connection
Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.
This rating plate must never be removed.
The connection to the mains shall be done conforming to the regulations in force. Check that the power line is adequately grounded. Do not use reducers, adapters or shunts. On the power line, install an omnipolar cut- off device with contact
42
