Smeg ALFA41A, ALFA41DA Instructions for the installer, Oven Installation, Electrical connection

Instructions for the installer

3. OVEN INSTALLATION

The oven must be set up on a perfectly flat surface and left standing free. Make sure to allow enough room at the back for easy access to the terminal strip for connecting the power supply cable. Installation must be carried out by a qualified technician in compliance with EEC DIRECTIVES currently in force.

3.1 Electrical connection

Make sure the voltage and the cross-section of the power cord match the specifications indicated on the identification plate positioned on the side of

the oven. Do not remove this plate for any reason.

The oven is fitted with an H07RN-F three-core cable for operation at 230V∼ and a power supply plug.

The supplied cable is of the three-core 3 x 1.5 mm2 H07RN-F type.

The power supply cable must be replaced by the manufacturer or by an authorised service centre to prevent any risks.

The terminal marked with this symbol connects parts together that are normally at zero potential. Connect the appliances appropriately using this terminal in order to make sure that they are equipotential.

The plug and wall-mounted socket must be of the same type (in accordance with current regulations). Also check that the power supply line is provided with adequate earthing. Avoid use of adapters and shunts.

3.1.1 Safety thermostat

The oven is fitted with a safety device which trips in case of serious malfunction. To reset, contact the nearest technical assistance centre.

The manufacturer declines all responsibility for damage to persons

or things caused by the non-observance of the above prescriptions or deriving from tampering with any part of the appliance.

24