Instructions for the installer
2. INSTALLATION
2.1 Electric installation - mains supply
WARNING: This appliance must be earthed.
This appliance conforms with BSEN 55014 regarding radio frequency interference.
•The appliance must be connected by a competent electrical contractor / engineer such as one who is registered with the National Inspection Council for Electrical Contracting (NIEIC).
•A Double Pole Control Switch with a minimum contact clearance of 3 mm must be fitted on or recessed into the wall adjacent to the appliance and must be accessible after installation to enable the appliance to be isolated for cleaning or in case of an emergency.
•The appliance should be checked to ensure that the rated voltage corresponds with supply voltage.
•Color coding of wiring:
GREEN- and YELLOW
BLUE
BROWN
As the colours of the wires in the mains lead of this appliance may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: The wire coloured
with "E" or 
; The wire coloured Blue must be connected to the terminal marked "N" or coloured Black; The wire coloured Brown must be connected to the terminal marked "L" or coloured Red.
2.2 Electrical connection
Check that mains voltage and power cable ratings are as per the indications provided on the label attached to the oven door frame.
This label must never be removed.
It is obligatory for the electrical system to be grounded according to the methods required by safety rules.
If a plug and socket connection is being used make sure that the plug and socket are compatible. Avoid use of adapters and shunts as these could cause overheating and risk of burns.
If a fixed connection is being used fit power line with an omnipolar circuit breaker with a contact opening gap equal to or greater than 3 mm in an easily accessible position in proximity to the oven.
6
