User instructions

STARTING THE DISHWASHER

After carrying out all the operations described above correctly, to start the dishwasher simply press the press the START/PAUSE button (4) for a few seconds until a beep sounds (the PROGRAM STARTED (5) light starts to flash). The 3-FIGURE DISPLAY (12) will show the duration of the program in minutes. The duration time is only approximate, because it depends on the washing conditions (quantity of dishes, water temperature, etc.), and is also continually updated as the washing program progresses.

The 3-FIGURE DISPLAY (12) shows the estimated duration of the washing program.

If it is necessary to open dishwasher door during the washing cycle, there will be a 1-minute delay before the program can be resumed. After correctly closing the door, press the START/PAUSE (4) button again. This operation may negatively affective the progress of the washing cycle.

END PROGRAM

The end of the program is indicated by a short signal acoustic and from the “End” visual notification on 3-FIGURE DISPLAY (12). By pressing the PROGRAM SELECTION button (2), the “End” visual signal will vanish from the display and the dishwasher is ready to continue a new cycle, the same thing happens when closing or opening the door or by switching on-off the machine.

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.

15

Page 16
Image 16
Smeg LSPX1253 manual Starting the Dishwasher, END Program, Removing the Dishes