Technical Data | Smeg LSPX1253 specs

User instructions

TECHNICAL DATA

Width		597 599 mm

Depth measured flush with the		Free standing: 600 mm
outer edge of the control panel		Semi-integrated: 570 mm

Height (depending on models)		Free standing: from 850 mm to 870 mm
		from 890 mm to 910 mm
		Semi-integrated: from 820 mm to 870 mm
		from 860 mm to 910 mm

Capacity		12 Standard place settings

Water supply pressure		min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)

Electrical characteristics		See rating plate

32

Image 33

Smeg LSPX1253 manual Technical Data

Contents

Guide for Using the Dishwasher and the Washing Programs Contents Safety and operating instructions Safety instructions Safety instructions Aquastop Models For free-standing models only Installation and hook-up Connecting to the Water Supply Water supply connectionDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautions When Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only Front panel Description of the controls Bio Setting the Washing Program Before starting a washing program make sure that Washing programsCorrect amount of detergent has been added to the dispenser Programming Cancelling the Current Program Changing the ProgramSelecting Half Load Wash on some models only Delaying the Program Press the Program Delay button 6 again the 3-FIGURE DisplayAvailable in all programs except the soak program To Save on ENERGY! … and Protect the Environment Option Button Starting the Dishwasher END ProgramRemoving the Dishes Operating instructions Using the water softening system User instructions Water Hardness Table Using the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser Setting Adding the Detergent Products General warnings and recommendations User instructions Using the baskets Lower BasketLoading the Lower Basket Upper Basket Cutlery Basket Loading the Upper Basket Adjusting the Upper Basket Version B Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergents Fill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter Unit Reconnect the water intake hose and open the tap again If the dishes are not being cleaned properly, check thatIf the program fails to start, check that If water remains inside the dishwasher, check that If there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check that Troubleshooting Technical Data 135 145