User instructions
ξDo not use table salt as it contains insoluble substances which, over time, may damage the water softening system.
ξWhen necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion.
Be careful not to confuse the salt and detergent packages; adding detergent to the salt container will damage the water softening system.
ADJUSTING THE WATER SOFTENING SYSTEM (available in all programs except the soak program)
The dishwasher is equipped with an electronic device for adjusting the water softening setting according to the hardness of the water. To adjust the water softening setting, proceed as follows.
Keep the PROGRAM DELAY button (6) pressed for a few seconds, until the H- symbol, followed by the set value, appears on the
The PROGRAM DELAY button (6) can be pressed again to select the most suitable hardness value (H1, H2…H5). Refer to the "Water hardness table" to select the value.
To exit the programming mode press the START/PAUSE button (4) or do not touch the keypad for 2 seconds to allow the system to exit the mode automatically.
17
