Smeg S200EB/1 Instructions for the installer, Installing The Appliance, 14.1Electrical connection

Instructions for the installer

14.INSTALLING THE APPLIANCE

14.1Electrical connection

The I.D. plate with technical data, registration number and brand name is positioned visibly on the oven door frame.

The plate must not be removed.

It is obligatory for all electrical system to be grounded according to the methods required by safety rules.

If a fixed connection is being used fit power line with an omnipolar circuit breaker with a contact opening gap equal to or greater than 3 mm, in an easily accessible position in proximity to the oven.

If a plug and socket connection is being used make sure that the plug and socket are compatible. Avoid use of adapters and shunts as these could cause overheating and risk of burns.

For operation on 220-240V~: use an H05RR-F /H05RN-F type three-core cable (3 x 1.5 mm2).

The cable end to be connected to the appliance must be provided with a ground wire (yellow-green) at least 20 mm longer.

14.2 Positioning the oven

The oven is designed for mounting into any piece of furniture as long as it is heat-resistant. Proceed acording to the dimensions shown in Figures 1, 2 and 3. For installing under a work top, follow the dimensions given in Figure 1-3. For installing under a work top with combined heating plates, ensure a minimum clearance from any side walls of at least 110 mm as shown in Figure 1. For installing in a column, follow the dimensions given in Figure 1-2, allowing for a clearance of 80 to 90 mm at the top and sides of the column. Tighten the 4 screws A inside the frame (fig. 1). For installing beneath a non-integrated top, allow for a rear and bottom clearance as shown in Figure 1 (ref. B). See relevant instructions for fitting and securing the cook top.

63