Installation of the Appliance | Smeg SNZ61MFX guide

Instructions for the installer

2. INSTALLATION OF THE APPLIANCE

It is the law that all gas appliances are installed by authorised persons. Clearance around the cooker must comply with the requirements of AS5601.

2.1Electrical connection

Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

On the power line, install a two-pole cut-off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.

The wire section on the cable must not be less than 2.5 mm2 (3 x 2.5 cable), keeping in mind that the end to be connected to the cooker must have the ground wire (yellow-green) longer by at least 20 mm. Use only the special cables available at our Service Centres.

The manufacturer declines all responsibility for damage to persons or things caused by non-observance of the above prescriptions or by interference with any part of the appliance.

Overall dimensions: location of gas and electrical connection points (all measures in mm).

A 60

B 410

C 100

D 140

6

Image 4

Smeg SNZ61MFX manual Installation of the Appliance, Electrical connection, This rating plate must never be removed

Contents

Contents Introduction Instructions for Safe and Proper USE Introduction Electrical connection Installation of the ApplianceThis rating plate must never be removed Gas connection Room ventilation Clearance above and around domestic cookers Requirements Replacement of nozzles on the hob Adaptation to Different Types of GAS Burner LPG Propane 2.75 KPa Burner and nozzle characteristics tableBurner Adjustment of the hob burner minimum level for natural gas Adjustment of the hob burner minimum level for LPG PropaneFinal Operations Arrangement of the burners on the hob Mounting the rear top skirtboard where applicable Wall fixing Description of Symbols HOB Burner Command KnobDescription of Controls Front control panel Electric Oven Control Knob Clock adjustment Electronic ProgrammerList of Functions Semiautomatic cooking Automatic cooking Adjusting alarm volumeEnd of cooking Switching off the alarm Cancellation of set dataAnalogue clock only on equipped models Minute Counter USE of the HOB Lighting of the hob burners Practical advice for using the hob burners Diameter of containersBurners Min. and max USE of the Oven How to use the grillUse of the electric grill Storage compartment Food Grille on the Shelf Available Accessories Accessories on Request Function Switch Thermostat Selector Switch from 50 to 260C Cooking HintsTraditional cooking Hot-air cooking Function Switch Thermostat Switch from 50 to 200C Grill cookingHot-air grilling Make sure that the oven door is closed during cooking Delicate cooking Function Switch Thermostat Switch in PositionDefrosting Traditional Cooking Recommended cooking table HOT-AIR Cooking Cleaning stainless steel and enamelled versions Cleaning and MaintenanceCleaning of the hob components Door glass Cleaning of ovenSpark plugs and thermocouples Extraordinary Maintenance Replacement of light bulbsLubrication of gas taps Dismantling of the doors Preventive maintenance Oven door gaskets Problems and Causes Problem Cause What to do