Instructions for the User
USA
9.4When the oven is working…
9.4.1Interrupting a cooking cycle
You can stop the cooking process at any time by pressing the Start/Stop key once or by opening the oven door. In both cases:
Microwave emission is stopped immediately.
The grill is de-activated but is still very hot. Danger of burning!
The timer stops and the display shows the remaining amount of operating time.
If you wish, at this time you can:
Turn or stir the food to ensure it will be evenly cooked.
Modify the process parameters.
Cancel the process by pressing PT2 for 3 seconds. To restart the process, close the door and press PT2.
9.4.2Modifying parameters
The operating parameters (time, weight, power, etc.) can only be modified when the cooking process has been interrupted. Proceed as follows:
Turn PT2 to the right or left to change the function.
Press PT1 to activate the parameter modification mode. The 
symbol starts to blink. Turn PT1 to the right or left to change the remaining cooking duration.
Press PT1 to validate and the next parameter light starts to blink. Proceed as described in the active function chapter to modify the remaining parameters.
Press PT2 to continue the cooking process.
9.4.3Cancelling a cooking cycle
If you wish to cancel the cooking process, press PT2 for 3 seconds. You will then hear a beep and the oven returns to the OFF setting.
9.4.4End of a cooking cycle
At the end of the process you will hear three beeps and the display will show the word “End”.
The beeps are repeated every 30 seconds until the door is opened or PT2 is pressed. The oven returns to the OFF setting.
9.5Secondary menu
This appliance also has a concealed "secondary menu" allowing the user to:
1.Activate or deactivate the Show Room function (which disables all the heating elements so that only the control panel works);
2.Activate or deactivate the function which limits the maximum power absorption to 2000 W;
3.Activate or deactivate the child safety device (
);
9.5.1Show Room Function
With the oven in OFF status (see point “7.2 Operating settings”) keep PT1 pressed until the message OFF SHO appears on DSP1. This means that
18
