Smeg SY4110 Electrical connection, Instructions for the installer, five-corecable 5 x 1.5 mm2

Instructions for the installer

4.2 Electrical connection

Make sure the voltage and the cross-section of the power cord match the specifications indicated on the rating plate positioned in the storage compartment. Do not remove this plate for any reason.

If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out device on the line, with contact opening distance equal to or greater than 3 mm located near the appliance and in an easily reachable position.

Connection to the supply may be fixed or with plug and socket. In the latter case the plug and socket must be suitable for the cable employed and conform with the regulations in force. Regardless of the type of connection, it is compulsory that the appliance be earthed. Before connection make sure that the power supply line is suitably earthed. Avoid the use of reducers, adapters or shunts which may cause overheating.

The appliance comes with a terminal board on the back for electrical hook-up (see following diagram). To open the terminal board cover, remove the fixing screw and raise the cover.

For operation on 380-415V 3N~: use an H05V2V2-F type

five-core cable (5 x 1.5 mm2).

For operation on 380-415V 2N~: use an H05V2V2-F type four-core cable (4 x 2.5 mm2).

For operation on 220-240V~: use an H05V2V2-F type three- core cable (3 x 6 mm2).

The end to be connected to the appliance must be an earth wire (yellow-green) at least 20 mm longer.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE TO PERSONS OR THINGS CAUSED BY NON-OBSERVANCE OF THE ABOVE PRESCRIPTIONS.

8