Leveling the appliance
Water inlet connection
•Put the appliance in horizontal position by turning the adjustable legs.
The legs are adjustable up to +/- 1 cm.
After the adjustment tighten the nuts firmly (A)
- towards the bottom of the machine!
Vibrations, moving of the appliance and loud operation due to incorrect setting of the adjustable feet shall not be covered by this warranty.
The appliance should be placed on a surface with concrete base; the surface should be dry and clean in order to prevent slipping. The adjustable feet should also be cleaned before installation.
•If you have a tumble dryer of the same dimensions, you can place it on top of the washing machine.
To ensure correct operation of the appliance, water pressure inlet must be between 0,05 and 0,8 MPa.
Minimum water pressure can be established by measuring the quantity of poured out water. 3 litres of water must be poured out from completely opened tap in 15 seconds.
• Insert the gasket with screen into the water inlet hose thread Screw the hose thread to the water
faucet |
|
• In case of hot and cold water connection, connect |
|
one hose to cold and other to hot water faucet as |
|
marked at the rear of the appliance (letters C and | 187352 |
H) (C - cold; H - hot) |
