Instructions for the Installer
13.2 Positioning the oven
The appliance is designed for building-in to cabinets made from any heat- resistant material. Comply with the dimensions shown in figures 1, 2 and 3. When installing under worktops, comply with the dimensions shown in figure 1-3. When installing under worktops incorporating combined hobs, a gap of at least 110 mm must be left from any side wall, as shown in figure 1.
When installing in tall units, comply with the dimensions shown in figure 1- 2, bearing in mind that the top/rear of the unit must have an opening 80-90
mmdeep. Screw the 4 screws A into the inside of the frame (fig. 1). For installation under counter-top hobs, make sure that the rear/bottom of the unit has an opening similar to that shown in figure 1 (ref. B). See the instructions supplied with the hob for the relative positioning and fixing procedures.
65
