Snapper 1691998, 1691810 manual Belt

6 . Remove the capscrew, lockwasher, and flat washer securing right hand arbor pulley. Retain the washers for reinstallation (step 9). Use a wood block to prevent blade from turning.

SunRunnerNanguard Models

6.On early models without bet stop (A, figure 3) remove two self-tapping screws from arbor and install two .5/l 6-18 x l-1/2” capscrews (A, figure 3). Parts will be installed on these capscrews in steps 7 and 8 as shown in figures 3 and 4.

7.Install the bracket (F, figure 4) with hardware as shown in figures 3 and 4. On early models, install the rear belt stop (C) facing the inside of mower deck as shown in figure 4. Use washers (B & D) and lo&washer (H) only for securing belt stop (C) on early models. Use jam nut at locations A and E.

8 . On early models, install the front belt stop (D, figure

3)onto front capscrew (installed in step 6) with washer,lockwasher,andnut.Tightensnugonly.The

beL stop should face the inside of mower deck as shown in figure 3.

Figure	3. (Early	Model)
A. capscrews, l-112’			C.	Rear	Belt	Stop
B. Rear	Mounting	Bracket	D.	Front	Belt	Stop

Figure 3A. (Later Model)

A. Ben Stop (Existing)

B. Rear Mounting Bracket

FCll3OO Models

6.On later models with factoty-installed belt stop (A, figure 3A), it is not necessary to change capscrews as new belt stops are not required.

7.install the bracket (F, figure 4) with hardware as shown in figure 3A and 4. Use jamnuts (A & E, figure

4)to secure bracket (F).

(A, figure 3A).

Figure 4.		G. Capecrew, 6116-18 x l-112
A. Jam Locknut,	5/16
B. Washer, 5116		H. Lockwasher, 5/16
c. Beit stop		I. spacer
D. Washer, 5116		J. Washer, spaal
E. Jam Locknuf	5116	K. Screw, Self-Tapping, I/4-20
F. Arbor Bracket		L. Left-Hand Mtg. Hole

9