installation - Lawn ,Tractors
NOTE
Two spacers are packaged with turbo biower.
Installation on tractor requires use of
4-l/16”
spacer (see step 11); the
1/2”spacerwill
not be
used.
1. Remove mower deflector and arbor cover as
follows:
a. Remove the mower deflector by removing
two carriage bolts, lockwashers and nuts.
Install this hardware on the deflector for use
when blower is removed for side discharge.
b. Remove the right hand arbor cover (A, figure
1) by removing washers and nuts in frontthat
hold cover to deck. Also, remove nuts
(8)
and
washers that secure rear tabs to arbor.
2. Slip mower belt off the right hand pulley.
Remove the pulley from the arbor by removing
capscrew
(D, figure 2) and washers (F). Save
washers for reinstallation. Use wood block to
orevent blade from turning.
NOTE
Later model decks have
l-1/2”
taptite screws,
rather than 1” taptite screws, location A, figure
2. If capscrew protrudes 5/S” above arbor, new
capscrews do not need to be installed
3. Remove brake spring or spring anchor (if
equipped) and two taptite screws from arbor at
locations A, figure 2. Replace these with two
5/16-18x l-1/2 capscrews (A).
A.
capscrew
D.
capscrew
B. Arbor Bracket E. Belt Stop, Front
C. Notch F. Washers
4. Before installing arbor bracket (B, figure 2 &A,
figure3),
removewasherfrom underneath blade
brake bracket (rear capscrew). Arbor bracket is
same thickness as washer and will replace
washer. Loosen the front flange nut and remove
the rear flange nut on the blade brake bracket.
NOTE
Rear belt stop should be installed facing inside
of deck.
5. Install the arbor bracket (A, figure 3) and rear
belt stop (B) as shown. Note the different holes
for the 42” and 43” mowers. On the 42” deck,
install a
jamnut
at rear bracket location instead
of flange whiz nut. Tighten nut (F) snug only -
belt stop will be adjusted in step 8.
Figure 1.
A. Arbor Cover
B. Nut dover
Figure 2.
I.
Figure 3.
A Arbor Bracket C. CapSxew E.
Lockwasher
B. Belt Stop D. Large Washers F. Jam Locknut
3