16.Make sure that flat washer (F, figure 9) is on top of spacer assembly and install new arbor belt cover (A, figure 10) as shown in figure 10. Secure with flat washer
17.Install the blower assembly as follows:
a.Align th& notch on blower assembly with spacer on arbor bracket. Align spacer on blower assembly with notch on arbor bracket. Slide the assembly into place as shown in figure 10 while aligning front notch between cup and wing nut. Tighten wing nut (C, figure
10).
b.Raise the flap (D, figure 10) and install the blower drive belt (E) in the top groove of the pulley. Push on lever (F) to provide slack to install belt.
NOTE
On later models with single (front) belt stop, belt stop must be on outside of both mower belt and turbo belt.
Figure 10.
A. Arbor Cover ’
B.Locknut
C.Wing Nut
D.Flap
E.Blower Belt
F.Lever
G.Rat Washer
18.With belt installed, pivot arbor cover (A, figure
11)into position as shown in figure 11. Secure with rubber strap (B) to blower housing.
:igure 11.
A Arbor Cover 8. Rubber Strap
1 2
