G | F |
| |
| E |
| H |
| D |
| C |
| A |
| B |
Figure 14. Deflector Control Cable Support Arm
A.Support Arm
B.5/16-18 x 1 Capscrew
C.Lockwasher & Nut
D.3/8-16 x 1-1/4 Capscrew
E.Assist Lever
F.Spacer
G.Lockwasher & Nut
H.Large Washer
Initial Setup & Assembly
| G | H |
|
| |
| F |
|
A | B |
|
| C |
|
|
| D |
|
| E |
Figure 15. Install Power Port & Switch
A.Rotator Motor Harness
B.Trailer Plug
C.Switch Harness Lower Plug
D.Plug Hole (Frame)
E.Tractor Harness Leads
F.Switch Harness Upper Plug
G.Switch
H.Power Leads
Attach Deflector Control Cable Support Arm
&Assist Lever
1.Assemble the deflector control cable support arm (A, Figure 14) to the left side of the snowthrower using one
(C) using the holes shown.
2.If not already done, install the lift assist lever (E) using a
Install Chute Rotator Switch and Harness
1.Remove the plug from the switch mounting hole in the right side of the dashboard.
2.Route the switch harness (C, F, Figure 15) through the frame and dashboard as shown.
3.Install the switch (G) in the dashboard and connect the upper end of the switch harness (F) to it.
4.Connect the red/yellow power lead (H) to the red/yel- low tractor harness lead (E). Connect the black power lead to the black tractor harness lead.
5.Mount the trailer plug socket (B) in the frame at loca- tion (D). Connect the trailer plug lead (B) to the lower switch harness connector (C).
6.Do not connect the snowthrower wire harness (A) at this time.
17
