Contents
42” Single-Stage Snowthrower 46” Single-Stage Snowthrower
OPERATOR’S MANUAL
ATTACHMENT
1724186-06
Maintenance
Safety Rules & Information
Features & Controls
Troubleshooting, Adjustments & Service
PREPARATION
Safety Rules & Information
TRAINING
OPERATION
CHILDREN
Safety Rules
SERVICE, MAINTENANCE, AND STORAGE
CLEARING A CLOGGED DISCHARGE CHUTE
Safety Decals
SAFETY DECALS
Recommended Accessories
Safety Information
Required Accessories
DANGER
B. PTO Switch
Features Controls
A. Electric Spout Rotator Switch
CONTROL FUNCTIONS
Engine & Ground Speed Selection
General Operating Instructions
Checks Before Starting
Starting & Stopping
Daily Storage
General Operating Instructions
Snow Removal Suggestions
Off-Season Storage
General Lubrication
Maintenance
Schedule For Normal Care
Lubricate Discharge Chute
Inspect, Adjust, & Lubricate Drive Chain
Maintenance
Lubricate Auger Bearings
Troubleshooting, Adjustments, & Service
TROUBLESHOOTING
Skid Shoe Adjustment
Troubleshooting, Adjustments, & Service
Drive Chain Adjustment
Electric Chute Rotator Gear
Troubleshooting, Adjustments, & Service
Lift Rod Adjustment
IMPORTANT NOTE
Belt Replacement
Belt Tension Adjustment
Troubleshooting, Adjustments, & Service
Description
Initial Setup & Assembly
Figure 10. Initial Setup
Description
Install Hitch
Initial Setup & Assembly
INITIAL SETUP & ASSEMBLY
Install Skid Shoes
Attach Deflector Control Cable Support Arm Assist Lever
Install Chute Rotator Switch and Harness
Initial Setup & Assembly
Mount Remote Deflector Control
Initial Setup & Assembly
Install Snowthrower
Initial Setup & Assembly
Initial Setup & Assembly
4. Lift the snowthrower up fully and support with wood blocks
Initial Setup & Assembly
8. Route the drive belt as shown in Figure 23. Note that the back of the belt rides in the back-side idlers
Removal Normal Installation
Removal
Normal Installation
Removing & Installing the Snowthrower
Hydraulic Lift Models
LIFT VARIATIONS WHEN USING ATTACHMENTS
Tractor Lift Linkage
Manual Lift Models
Nut, 1/2”
Torque Specification Chart
Hardware Identification & Torque Specifications
Screw, 1/2
MOUNTING REMOTE DEFLECTOR CONTROL
Mounting Remote Deflector Control
NOTE Read through instructions before beginning
Mark and Drill One 9/32” Hole
Template
Line Template Up with Top Crease of Plastic Dashboard
Line Template Up with Edge of Plastic Dashboard
Template