Snapper 1694144, 1694295, 1694150, 1694296 manual Initial Setup & Assembly

Initial Setup & Assembly

INSTALL ASSIST SPRING

4.Lift the snowthrower up fully and support with wood blocks.

5.Assemble the lift assist spring (B, Figure 21) and spring bracket (C). Install the spring assist bracket

(C) in the front bumper. Be sure the spring notch is in the lower position.

6.Rotate the assist spring lever (A) backwards. Hook the spring (A) on the lever (C) and rotate the lever forwards.

CAUTION

Spring under tension. Keep clear of pinch points.

7. Lower the snowthrower.

NOTE: If necessary, perform the lift rod adjustments found in the Troubleshooting, Adjustments, & Repair section.

CONNECT ELECTRICAL HARNESS

8.Route the wire harness through the bottom opening in the grille and along the frame rail to the accessory plug (B, Figure 22). Connect the chute rotator har- ness plug (A, Figure 22) to the tractor plug (B). Make certain it will not be caught in the front axle pivot. Secure with the wire clips provided.

C

B

A

Figure 21. Lift Assist Spring

A. Assist Spring Lever C. Spring Bracket

B. Assist Spring

B

A

A

Figure 22. Rotator Motor Electrical Connection

A.Rotator Motor Harness & Plug

B.Tractor Plug

20