Contents
OPERATOR’S MANUAL
ATTACHMENT
42” Single-Stage Snowthrower 46” Single-Stage Snowthrower
1724186-06
Safety Rules & Information
Features & Controls
Maintenance
Troubleshooting, Adjustments & Service
Safety Rules & Information
TRAINING
PREPARATION
OPERATION
Safety Rules
SERVICE, MAINTENANCE, AND STORAGE
CHILDREN
CLEARING A CLOGGED DISCHARGE CHUTE
Safety Decals
SAFETY DECALS
Safety Information
Required Accessories
Recommended Accessories
DANGER
Features Controls
A. Electric Spout Rotator Switch
B. PTO Switch
CONTROL FUNCTIONS
General Operating Instructions
Checks Before Starting
Engine & Ground Speed Selection
Starting & Stopping
General Operating Instructions
Snow Removal Suggestions
Daily Storage
Off-Season Storage
Maintenance
Schedule For Normal Care
General Lubrication
Lubricate Discharge Chute
Inspect, Adjust, & Lubricate Drive Chain
Maintenance
Lubricate Auger Bearings
Troubleshooting, Adjustments, & Service
TROUBLESHOOTING
Troubleshooting, Adjustments, & Service
Drive Chain Adjustment
Skid Shoe Adjustment
Electric Chute Rotator Gear
Troubleshooting, Adjustments, & Service
Lift Rod Adjustment
IMPORTANT NOTE
Belt Replacement
Belt Tension Adjustment
Troubleshooting, Adjustments, & Service
Initial Setup & Assembly
Figure 10. Initial Setup
Description
Description
Initial Setup & Assembly
INITIAL SETUP & ASSEMBLY
Install Hitch
Install Skid Shoes
Attach Deflector Control Cable Support Arm Assist Lever
Install Chute Rotator Switch and Harness
Initial Setup & Assembly
Mount Remote Deflector Control
Initial Setup & Assembly
Install Snowthrower
Initial Setup & Assembly
Initial Setup & Assembly
4. Lift the snowthrower up fully and support with wood blocks
Initial Setup & Assembly
8. Route the drive belt as shown in Figure 23. Note that the back of the belt rides in the back-side idlers
Removal Normal Installation
Removal
Normal Installation
Removing & Installing the Snowthrower
LIFT VARIATIONS WHEN USING ATTACHMENTS
Tractor Lift Linkage
Hydraulic Lift Models
Manual Lift Models
Torque Specification Chart
Hardware Identification & Torque Specifications
Nut, 1/2”
Screw, 1/2
MOUNTING REMOTE DEFLECTOR CONTROL
Mounting Remote Deflector Control
NOTE Read through instructions before beginning
Template
Line Template Up with Top Crease of Plastic Dashboard
Mark and Drill One 9/32” Hole
Line Template Up with Edge of Plastic Dashboard
Template