Snapper 1695164 manual Initial Installation, Hitch Installation

Initial Installation

WARNING

Before beginning any service work turn off the PTO, set the parking brake, turn off the ignition, and disconnect the spark plug wire(s).

Initial Installation

Hitch Installation

1.Slide the 5/16-18 speed nut (A, Figure 1) onto rear frame support (E) through square hole (C) so that the threaded side (B) is on the inside of tractor.

2.Secure the 5/16-18 shoulder bolt (D) as shown.

3.Repeat on the other side.

B

A

A

C

E

D

Figure 1. Install Spacer (left side shown)

A.Speed Nut, 5/16-18

B.Threaded Side

C.Square Hole

D.Shoulder Bolt, 5/16-18

E.Rear Frame Support

4.Slide the hitch (A, Figure 2) on right side and left side shoulder bolts (B) while sliding post (C) into hole (D) as shown. Secure with hair pin (E).

A

D

C

E

B

Figure 2. Hitch Installation

A.Hitch

B.Shoulder Bolt

C.Post

D.Hole in Draw Bar

E.Hair Pin

4