Snapper 42" Single-Stage Snowthrower manual Install Hitch Onto Tractor, Initial Setup & Assembly

Initial Setup & Assembly

INSTALL HITCH ONTO TRACTOR

1.Remove mower deck.

2.Place hitch on floor in front of tractor, with the hitch mounting arms towards the rear of the tractor.

NOTE: If this is a new installation, cut the plastic ties holding the snow thrower drive belt for shipping, but do not remove the belt.

3.On underside of tractor frame, insert hitch support shaft (A, Figure 11) as shown and secure, with the hair pin cotter pin (B) on inside of frame. IMPORTANT – the hair pin cotter pin must be located along the inside edge of the tractor frame.

4.Slide hitch (A, Figure 12) under tractor and lift to slide hitch mounting arms (C) over hitch support shaft (B).

5.At front of the machine, locate and remove the hitch latch pin (A, Figure 13) from the hitch assembly (B).

6.Turn the front wheels fully to the left.

A

B

Figure 11. Install Hitch Support Shaft

A.Hitch Support Shaft

B.Hair Pin Cotter

C

B

A

Figure 12. Hitch Installation

A.Hitch Assembly

B.Hitch Support Shaft

C.Hitch Mounting Arms

C

A

D

B

Figure 13. Hitch Latch Pin Installation

16