Operator Safety

 

 

Safety Interlock System

 

 

Safety Alert Symbol & Signal Words

 

 

 

 

 

 

 

 

The alert symbol

is used to identity safety

 

 

 

 

 

 

 

information about hazards that can result in personal

 

 

 

 

 

 

 

injury. A signal word (DANGER, WARNING, or

This unit is equipped with safety interlock switches.

CAUTION) is used with the alert symbol to indicate

the likelihood and the potential severity of the injury.

These safety systems are present for your safety,

 

In addition, a hazard icon may be used to represent

do not attempt to bypass safety switches, and never

the type of hazard. An explanation of hazard levels

tamper with safety devices. Check their operation

 

and icons are as follows:

regularly.

 

 

 

 

 

 

 

 

 

 

DANGER

 

 

 

 

 

 

 

Operational SAFETY Checks

 

 

 

This indicates a hazard which, if not avoided, will

Test 1 — Engine should NOT crank if:

 

 

result in serious injury or death.

 

 

 

 

 

 

 

 

 

• PTO switch is engaged, OR

 

 

 

 

WARNING

 

• Parking brake is not engaged, OR

 

 

 

This indicates a hazard which, if not avoided, could

 

• Motion control handles are not in the NEUTRAL

result in serial injury or death.

 

position.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CAUTION

Test 2 — Engine SHOULD crank if:

 

 

 

 

 

 

This indicates a hazard which, if not avoided, might

 

• PTO switch is NOT engaged, AND

 

 

 

 

 

esult in minor or moderate injury.

 

• Parking brake is engaged, AND

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• Motion control handles are locked in the

 

 

NOTICE

 

 

NEUTRAL position.

 

 

 

 

These messages presented without the alert symbol

Test 3 — Engine should SHUT OFF if:

 

 

 

 

indicate a s ua on where the unit or property could

 

 

 

 

 

 

for

 

 

• Operator rises off seat with PTO engaged, OR

 

be damaged.

 

 

• Operator rises off seat with parking brake

 

 

 

 

 

disengaged.

 

 

 

 

 

 

 

• Operator moves motion control handles out of

 

 

 

 

their neutral positions before disengaging parking

 

 

 

brake.

 

Not

 

 

Test 4 — Blade Brake Check

 

 

 

 

 

 

 

 

 

Mower blades and mower drive belt should come

 

 

 

to a complete stop within seven (7) seconds aft

r

 

 

 

electric PTO switch is turned off (or op rator ris

s off

 

 

seat). If mower drive belt does not stop within seven

 

 

(7) seconds, see your dealer.

Reproduction

 

 

 

NOTE: Once the engine has stopped, PTO switch must be turned off, parking brake must be engaged, and the motion control handles must be locked in the NEUTRAL position after the operator returns to the seat in order to start the engine.

WARNING

If the unit does not pass a safety test, do not operate it. See your authorized dealer. Under no circumstance should you attempt to defeat the purpose of the safety interlock system.

12

www.SnapperPro.com