Foot Pedal Adjustment
The deck lift foot pedal can be adjusted to accommodate the operator’s height for optimal comfort.
To adjust pedal position:
1.Remove the foot pedal (A, Figure 4) from the pedal mount tab (B).
2.Remove the pedal mount hardware (C) and rotate the tab 180 degrees.
3.Reinstall the pedal mount hardware and tighten securely.
4.Reinstall the foot pedal on the pedal mount tab in the proper orientation as shown in Figure 4.
Operation
B
AC
D
Figure 4. Foot Pedal Adjustment
A.Deck Lift Foot Pedal
B.Pedal Mount Tab
C.Pedal Mount Hardware
D.Optional Position
Raise and Lower the Roll Bar |
|
| |
2. Push or pull the top of the roll barRepro(C) forward duction | |||
WARNING |
| for |
|
| C |
| |
AVOID SERIOUS INJURY OR DEATH FROM |
| D | |
ROLL OVER: | Not |
|
|
Keep roll bar in the raised position and use he |
|
| |
seat belt. |
|
|
|
THERE IS NO ROLL OVER PROTECTION WHEN |
|
| |
THE ROLL BAR IS DOWN |
|
|
|
Lower the roll bar only when necessary and |
|
| |
NEVER remove it. |
|
|
|
Do NOT use seat belt when the roll bar is down. |
|
| |
Raise the roll bar as soon as clearance ermits. |
| A | |
Do NOT jump off if mower tips. |
| B |
|
|
| D | |
|
|
| |
To Lower the Roll Bar: |
|
|
|
1. Pull the hair pin clips (A, Figure 5) out of the |
|
| |
retainer pins (B). |
|
|
|
against the rubber stops (D) and remove the | Figure 5. Raise & Lower the Roll Bar | ||
A. Hair Pin Clip |
| ||
retainer pins (B). |
|
| |
| B. Retainer Pin |
| |
3. Lower the roll bar into the down position (see |
| ||
C. Roll Bar |
| ||
insert, Figure 8). |
|
| |
| D. Rubber Stop |
|
To Raise the Roll Bar:
1.Pull the hair pin clips (A) out of the retainer pins
(B) and remove the retainer pins.
2.Raise the roll bar (C) until the rubber stops (D) contact the upright tubes.
3.Push or pull the top of the roll bar forward against the rubber stops and reinstall the retainer pins and hair pin clips to secure the roll bar in the raised position.
17