Operation
Starting and Operation
Engine (Electric Start)
IMPORTANT: When the ignition key is turned to “START”, the engine will turn over, but will not start unless the Clutch/Brake pedal is pressed all the way down, and the Blade Lever is in the “OFF” position. The operator should be in the seat.
Start the engine as follows:
1.Move the transmission shift lever to the (N) Neutral position. Refer to the section entitled “Wheel Drive”.
IMPORTANT: DO NOT start the engine with the transmission shift lever in a drive position.
A |
Figure 5: Engaging the clutch/brake pedal
! | WARNING |
| ! |
|
|
|
|
It is possible to start the engine with the transmission |
|
|
|
|
| ||
down and hold while starting the engine.Reproduction |
| ||||||
shift lever in a drive position. Follow starting instructions | for |
|
| ||||
carefully. |
|
|
|
|
|
|
|
2. Make certain the Blade Lever (A, Figure 4) is in the |
|
|
| B |
| ||
“OFF” position. |
| Not |
|
|
| ||
| A |
|
|
|
|
|
|
|
|
|
|
|
| A |
|
|
|
|
|
| Figure 6: Engine speed control |
| |
Figure 4: Blade lever (in ‘Off’ position) |
|
|
|
|
| A | |
|
|
|
|
|
|
| |
3. Press the Clutch/Brake Pedal (A, Figure 5) all the way |
|
|
|
| |||
4. Move the engine speed control (A, Figure 6) to the |
|
|
|
|
| ||
choke position (B) to start a cold engine. |
|
|
|
|
| ||
5. Turn the ignition key (A, Figure 7) to the “START” |
|
|
|
|
| ||
position until the engine starts. |
|
|
|
|
|
| |
NOTE: If after 5 seconds of cranking the engine does not |
|
|
|
| |||
start, release the key, make sure the Clutch/Brake Pedal is |
| Figure 7: Ignition key |
| ||||
fully depressed, and attempt starting again after waiting for |
| ||||||
approximately 20 seconds. |
|
|
|
|
|
| |
6.After the engine starts, move the engine speed control to the “FAST” position and allow a brief
(Continued on Next Page)
11
