Snapper P/N 7078273 a Remove bolts securing impeller pulley cover to blower, and remove cover

Models: 0-50576 P/N 7078273

1 28
Download 28 pages 34.61 Kb
Page 6
Image 6
STEP 6a: Remove bolts securing impeller pulley cover to blower, and remove cover.

STEP 6a: Remove bolts securing impeller pulley cover to blower, and remove cover.

REMOVE BOLTS,

HEN REMOVE

OVER

STEP 6b: Check to see that blower belt is routed around impeller pulley and idler pulleys after belt is installed onto deck pulley. Then replace cover. Tighten bolts securely. IMPORTANT: Never oper- ate any mower without a pulley guard securely in place.

STEP 7: Slip tube of locking pin bracket into blow- er mount, and secure with T-handle pin, making sure pin goes through both upper and lower part of blower mount. Then align base of pin bracket par- allel with rear of deck, and, using bracket as a tem- plate, drill two 7/16" holes through deck. Insert two 3/8-16 x 1" bolts up through deck and bracket, securing with hex flange nuts. Tighten securely. IMPORTANT: Use gloves when working under deck. Sharp blades can cause injury.

STEP 8: Lay supplied pulley guard onto deck. Align hole in front flange with front mounting hole in deck, and secure with one of the two bolts securing original guard. Do not tighten yet.

Align side flange of guard with side of deck, and, using other hole in guard as a template, drill one 9/32" hole in deck and install other bolt. (NOTE: Bolt is self-tapping.) Tighten both bolts securely.

6

Page 6
Image 6
Snapper P/N 7078273, 0-50576 manual a Remove bolts securing impeller pulley cover to blower, and remove cover