Snapper P/N 7078273, 0-50576 manual Slip looped end of cover support cord

INSERT PIN

INTO ROD

HOOK BAGGER FRAME ONTO BUMPER MOUNT PLATE PINS

CROSS ASSEMBLY

HEADROUNDPIN I

STEP 13: Hook bottom of bagger frame onto pins in bottom of bumper mount plate. Then slide lock- ing rod through aligned holes in bagger flame and bumper mount plate, securing with bridge pin.

STEP 14: Install cross assembly onto bagger frame with four 3/8-16 x 3/4 bolts and hex flange lock nuts, tightening securely. Insert bolts back through bagger frame and into cross assembly.

STEP 15: Insert two 5/16-18 x 3/4 bolts through reinforcement plate (not shown; refer to Parts List

-Catcher Mount Group), then through holes in bagger frame. Install cover latch arm onto bolts and secure with hex flange lock nuts, tightening securely. NOTE: Use the leftmost set of holes in the bagger frame when installing arm.

STEP 16: Lay cover assembly on cross assembly. Align hinges on cross assembly with hinges on cover, and install one round head pin through each set of hinge holes, securing with a hair pin.

STEP 17: Slip looped end of cover support cord

onto threaded stud on hose adapter assembly. Secure end of cord with one 3/16" flat washer and

10-32 nyloc nut (not shown). Run nut all the way in on thread, but leave cord loose enough to swivel.

8