•Trigger Operation:
−Scan always: Select if you would like the CHS to scan whether or not it has a Bluetooth connection to the host device.
−Scan only when connected to host: Select if you would like the CHS to detect a Bluetooth connection to the host device before it scans. Scanning will be a few milliseconds slower. This option allows the CHS to be triggered remotely if needed.
•Good Read Indicator: Select how would like the scanner to indicate that data has been successfully scanned and transmitted to the host device.
−Beep: If desired, select the KHz of the beep used to indicate good reads. If operating the CHS in a noisy environment, adjust the KHz as needed.
−Flash green LED: Check to have the CHS LED flash green to indicate good reads.
The delay in the ‘good scan’ indicator increases with the distance from the host, giving the user valuable feedback about the strength of the connection.
•CHS Battery Level: No progress bar should appear since you have not yet connected to the CHS. Later, when the CHS is connected to your Pocket PC, you can return to this utility to view the battery level.
•Disable CHS Auto Power Off mode: By default, the CHS will automatically shut off if no Bluetooth connection has been established for 20 minutes. Check the box to disable this mode.
5.After modifying any settings, tap ok. If you enabled the Flash green LED setting, the CHS will beep once to confirm. If SocketScan is already open, you must close and reopen SocketScan for the changes to take effect.
16