37
DAB1 DISTRIBUTED AUDIO SYSTEM
NOTE: If the desired remote is not in the library,
try using a similar product remote from that man-
ufacturer. If that doesn’t work, see Adding IR
Codes to the User IR Library with the OptiLinQ®
IR Learner, on page 39.
5. Select the device. Its commands will appear in the
small IR COMMAND WINDOW on the MACRO EDITOR
Screen (see
Figure 47
).
6. Select the desired command in the list and drag it to
the screen’s large MACRO window. (In this example,
the PAUSE command — see
Figure 48
).
7. Click OK. The MACRO EDITOR screen will disappear.
There should now be a MACRO INDICATOR on the
Source 2 STOP button on the PRESS level.
8. Select the PRESS-AND-HOLD button action level. The
MACRO INDICATOR should disappear from the Source
2 STOP button.
9. Right-click on the Source 2 STOP button.
10. Select the STOP command from the IR Command
Window and drag it into the MACRO WINDOW.
11. Click OK. MACRO EDITOR screen will disappear.
There should now be a MACRO INDICATOR on the
Source 2 STOP button on the PRESS-AND-HOLD level.
PROGRAMMED IR OUTPUT PORT SELECTOR
The default PROGRAMMED IR Port settings match the four
input sources: Programmed IR Port 1 = Source 1, etc.
You can use the PROGRAMMED IR OUTPUT PORT SELECTOR to
route the commands to other ports by selecting the
desired port
before
you drag the command into the
MACRO WINDOW.
In a system that has duplicate same-make/same-model source components, routing macro IR commands out of the COMMON
IR outputs will cause both of those components to respond to all macro commands for that component. If you want to retain
individual control of the components in macros you will need to connect IR emitters to two PROGRAMMED IR outputs and
create separate macro commands for each component, with those commands routed to individual PROGRAMMED IR outputs
for each component.
For example, in a system with duplicate CD changers connected to the DAB1’s SOURCE 3 and SOURCE 4 inputs, connect the IR
emitter for the SOURCE 3 CD player to PROGRAMMED IR OUTPUT #3 and the IR emitter for the SOURCE 4 CD player to PROGRAMMED
IR OUTPUT #4. Make sure that all of the IR macro commands for the SOURCE 3 CD player are routed to PROGRAMMED IR PORT
Select
IR Command
Programmed
IR Output Port
Selector
Drag Command
into Macro Window
Figure 48:
Dragging Commands into the MACRO WINDOW
IR Command
Window