Rack Installation Instructions
Review the documentation that comes with your rack cabinet for safety and cabling information. Before installing your server in a rack cabinet, review the following guidelines:
vMake sure that the room air temperature is below 35°C (95°F).
vDo not block any air vents; usually, 15 cm (6 in.) of air space in the rear and 5 cm (2 in.) in the front provides proper airflow.
vPlan the device installation starting at the bottom of the rack cabinet.
vInstall the heaviest device in the bottom of the rack cabinet.
vDo not extend more than one device out of the rack cabinet at the same time.
vRemove the rack doors and side panels to provide easier access during installation.
vConnect the server to a properly grounded outlet.
vDo not overload the power outlet when installing multiple devices in the rack cabinet.
vThe slide rails in this kit come preset to the correct length for installation in an IBM rack cabinet, and they are adjustable for other rack cabinets.
vThe slide rails are marked (RIGHT/FRONT and LEFT/FRONT) for proper placement on the
This symbol identifies a Caution statement. Always read the information that accompanies this symbol before you proceed with the installation.
Safety Information, Statement 4
Use safe practices when lifting. | ≥18 kg (39.7 lb) | ≥32 kg (70.5 lb) | ≥55 kg (121.2 lb) | ||||||||
| |||||||||||
Rack Safety Information, Statement 6 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Do not place any objects on top of a
This server does not require any tools for the installation procedure unless you are shipping the server in the rack cabinet. If you are shipping the server in the rack cabinet, you need a Phillips screwdriver. The following illustration shows the items that you need for installing the server in a rack cabinet. If any items are missing or damaged, contact your place of purchase.
Page 32
