Chapter3

Dubbing/Editing

Dubbing to another equipment

This section describes the connections and settings necessary to perform dubbing on other equipment, using this unit as a video player.

Connections for Dubbing

Notes

•For connection of the editing controller and its peripheral devices, refer to the instruction manual of the editing controller and that of the editing software you use.

•Edit functions are specified by the editing software. For details on the editing methods, refer to the instruction manual of the editing software.

•You cannot use the DSR-25/45-equipped duplicate function to dub a tape recorded in HDV/DV format via the i.LINK connection. Use the procedure in this chapter to perform dubbing.

To digital video equipment with an i.LINK jack

Connect this unit to the recorder as shown below using an i.LINK cable.

The signal flow is automatically detected so you do not need to make separate connections for input and output. Also, connecting the unit to an editing controller via HDV/DV jacks, you can configure a digital non-linear editing system.

For connections of the editing controller and this unit, refer to the editing controller instruction manual.

Monitor

Rear view of the player (this unit)

i.LINK cable (not supplied)

 

i.LINK jack

Monitor

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Digital video equipment with an i.LINK jack

: Signal flow

Before dubbing, you must set the format in which you want to output signals. Perform the [VCR HDV/DV] (p. 48) and [i.LINK CONV] (p. 49) settings of the [IN/ OUT REC] menu.

For details, refer to “Compatibility of HDV, DVCAM, and DV Formats” (p. 68).

Dubbing/Editing 3 Chapter

(Continued)

Chapter 3 Dubbing/Editing

35