Location and Function of Parts
Overview 1 Chapter
Front Panel
1 Indicator section
(see page 8)
1 1 (on/standby) switch/ |
|
1 (on/standby) lamp |
|
| 6 Operation panel |
2 Remote sensor |
|
| 2 Tape transport control |
3 PHONE LEVEL control knob | section (see page 13) |
4 PHONES jack
5LCD monitor
1 1 (on/standby) switch/ 1 (on/standby) lamp
Press this switch to turn the unit on. The 1 on/standby lamp lights up in green.
2Remote sensor
3PHONE LEVEL control knob
Controls the volume of the headphones connected into the PHONES jack 4.
4PHONES jack
Connect stereo headphones for monitoring sounds during the recording or playback. The audio signal you want to monitor can be selected in [AUDIO MONI] on the [AUDIO SET] menu. (p. 47)
5LCD (Liquid Crystal Display) monitor Displays the playback or EE1) pictures. Also, superimposed time data, status information, menus, audio level meters, etc. are displayed.
6Operation panel
1Indicator section
1 q (cassette) indicator
2 CHG (charge) indicator
3 50 indicator
4 60 indicator
5 HDV indicator
6 DVCAM indicator
7
8
........................................................................................................................................................................................................
1)“EE” stands for “Electric to Electric.” In EE mode, the video and audio signals input to the VCR’s recording circuitry do not pass through any magnetic conversion circuits but output via electric circuits only. This mode is used to check the input signals and adjust input levels. The pictures output in EE mode are referred to as EE pictures.
8 | Chapter 1 Overview |