If you are unable to remedy the problem using the troubleshooting guide

Clearing the receiver’s memory may remedy the problem (page 25). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.

If the problem persist

Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained.

Reference sections for clearing the receiver’s memory

To clear

See

All memorized settings

page 25

 

 

Customized sound fields

page 49

 

 

Specifications

Amplifier section

Models of area code CEL, CEK, ECE, AU1) Minimum RMS Output Power (8 ohms, 20 Hz – 20 kHz, THD 0.09%)

85 W + 85 W

Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%)

100 W + 100 W

Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%)

130 W/ch

Models of area code TW1)

Minimum RMS Output Power (8 ohms, 20 Hz – 20 kHz, THD 0.09%)

70 W + 70 W

Stereo Mode Output Power (8 ohms, 1 kHz, THD 1%)

100 W + 100 W

Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%)

130W/ch

1)Measured under the following conditions:

Area code

Power requirements

 

 

 

 

 

 

CEL, CEK, ECE

230 V AC, 50 Hz

Additional

 

 

2)Reference power output for front, center and

AU

240 V AC, 50 Hz

 

TW

110 V AC, 60 Hz

 

 

surround speakers. Depending on the sound field

Information

 

settings and the source, there may be no sound

 

output.

 

 

 

Frequency response

 

 

 

Analog

10 Hz – 70 kHz

 

 

+0.5/–2 dB (with sound

 

 

field and tone bypassed)

 

continued

67GB