The table below shows the display when measurement starts.

Measurement for

Display

Environment noise

NOISE.CHK

level

 

 

 

Speaker connection

MEASURE and SP

 

DET. appears

 

alternately*

 

 

Speaker level

MEASURE and GAIN

 

appears alternately*

 

 

Speaker distance

MEASURE and

 

DISTANCE appears

 

alternately*

 

 

*The corresponding speaker indicator lights up in the display during measurement.

When measurement ends, “COMPLETE” appears on the display and the settings are registered.

After you have finished

Disconnect the optimizer microphone from the receiver.

Notes

•Auto Calibration cannot detect the sub woofer. Therefore, all sub woofer settings will be maintained.

•If you have changed the position of the speaker, it is recommended that you perform Auto Calibration again to enjoy the surround sound.

Tip

During the measurement process, Auto Calibration is canceled when you do the following.

–Press ?/1 or MUTING.

–Press the input buttons or turn INPUT SELECTOR on the receiver.

–Change the volume level.

–Connect the headphones.

Error and warning codesWhen error codes appear

When an error is detected during Auto Calibration, an error code will appear on the display cyclically after each measurement process as follows:

Error code t blank display t (error code t blank display)a) t PUSH t blank display

tENTER

a)Appears when there are more than one error code.

To rectify the error

1Record down the error code.

2Press .

3Press ?/1 to turn off the receiver.

4Rectify the error.

For details, see “Error code and remedies” below.

5Turn on the receiver and perform Auto Calibration again (page 27).

Error code and remedies

Error

Cause and remedy

code

 

ERROR 10 The environment is too noisy. Make sure the environment is quiet during Auto Calibration.

ERROR 11 The speakers are placed too near the optimizer microphone. Place your speakers further away from the optimizer microphone.

ERROR 12 None of the speakers are detected. Make sure that the optimizer microphone is connected properly and perform Auto Calibration again.

ERROR 20 Front speakers are not detected or only one front speaker is detected. Check the front speakers connection.

ERROR 21 Only one surround speaker is detected. Check the surround speakers connection.

28GB