•Code 31

1 Press .

2Perform the Auto Calibration again.

•Code 32, 33

1When you press , “RETRY? YES” appears.

2Press V/v to select “RETRY? YES”, then press

.

3Perform the Auto Calibration again.

When you select “WARNCHECK”

If a warning on the measurement result is present, detailed information is displayed.

Press to return to step 1 of “Confirming/saving the measurement results” (page 33).

AUTO CAL menu parameters

You can use the AUTO CAL menu to make various adjustments for Auto Calibration settings and to name inputs.

Select “AUTO CAL” in the amplifier menus. For details on adjusting the parameters, see “Navigating through menus” (page 42) and “Overview of the menus” (page 43).

xA.CAL START (Auto Calibration)

xCAL TYPE (Calibration type)*

•FULL FLAT

Makes the measurement of frequency from each speaker flat.

•ENGINEER

Sets the frequency characteristics to a set that matches that of the Sony listening room standard.

•FRONT REF

Adjusts the characteristics of all speakers to match the characteristics of the front speaker.

•OFF

Sets the Auto Calibration equalizer level to off.

*You can select this parameter only when you have performed the Auto Calibration and saved the settings.

xPOSITION (Position)

You can register 3 patterns as position 1, 2 and 3 (POS. 1, POS. 2 and POS. 3), depending on the seating position, listening environment and measurement conditions. You can also load the registered setting.

xNAME IN (Naming inputs)

You can rename the position name. For details, see “Naming inputs” (page 80).

36GB