Troubleshooting

If you experience any of the following difficulties while using the receiver, use this troubleshooting guide to help you remedy the problem.

Audio

There is no sound, no matter which component is selected, or only a very low-level sound is heard.

•Check that the speakers and components are connected correctly and securely.

•Check that all speaker cords are connected correctly.

•Check that both the receiver and all components are turned on.

•Check that MASTER VOLUME is not set to “VOL MIN”.

•Check that the SPEAKERS (OFF/A/B/ A+B) is not set to off (page 30).

•Check that headphones are not connected.

•Press MUTING on the remote to cancel the muting function.

•Check that you have selected the correct component with the input buttons (page 38).

•When only a very low-level sound is heard, check to see if NIGHT MODE is activated (page 61).

•The protective device on the receiver has been activated. Turn off the receiver, eliminate the short-circuit problem, and turn on the power again.

There is no sound from a specific component.

•Check that the component is connected correctly to the audio input jacks for that component.

•Check that the cord(s) used for the connection is (are) fully inserted into the jacks on both the receiver and the component.

There is no sound from one of the front speakers.

•Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones. If only one channel is output from the headphones, the component may not be connected to the receiver correctly. Check that all the cords are fully inserted into the jacks on both the receiver and the component. If both channels are output from the headphones, the front speaker may not be connected to the receiver correctly. Check the connection of the front speaker which is not outputting any sound.

•Make sure you have connected to both the L and R jacks of an analog component, and not only to either the L or R jack. Use an audio cord (not supplied).

There is no sound from analog 2 channel sources.

•Check that the INPUT MODE is not set to “AUTO” (page 75) and the DIGITAL and HDMI connection is not made for the selected input.

•Check that the INPUT MODE is not set to “COAX” or “OPT” for the selected input (page 75).

•Check that the DIGITAL ASSIGN function is not used to reassign the audio input of another source to the selected input (page 76).

There is no sound from digital sources (from COAXIAL or OPTICAL input jack).

•Check that the INPUT MODE is not set to “ANALOG” (page 75).

•Check that the ANALOG DIRECT function is not selected.

•Check that the DIGITAL ASSIGN function is not used to reassign the audio input of another source to the selected input (page 76).

92GB