Crane Merchandising Systems 678 Optional Or Mandatory Posivend, Hot Drink Setup/Programming Guide

HOT DRINK SETUP/PROGRAMMING GUIDE

OPTIONAL OR MANDATORY POSIVEND™

1. Press then until the display shows one of the following:

OPT’N POSI.V: The machine reverts to home switch operation of the ring motors if the PosiVend™ system cannot operate normally because of an obstruction in the cup station or for any other reason.

MUST POSI.V: The vending machine is operational only if the PosiVend™ system is determined to be working. Otherwise, the machine will go temporarily out of service until the blockage or other error is corrected.

2. Press

to switch between the two choices.

3. Continue.

SET UP THE POSIVEND™ ANTI-JACKPOT TIMER

1. Press then until the display shows AJP.TMR XXM.

XXrepresents how many minutes PosiVend™ will be disabled for either cup ring. The same value applies to the two timers

(one on each ring).

2.Enter a number using either keypad.

If any cup ring motor fails to deliver a cup on two consecutive at- tempts, the cup ring goes out of service. After the time set in step 2 has elapsed, the cup ring goes back in service and is given one more chance to deliver a cup. If cup delivery is again unsuccessful, the ring goes out of service until the machine is serviced. A suc- cessful delivery on any cup ring will reset the failed attempts for that particular cup ring. If both cup rings perform three consecutive failed attempts (and the PosiVend™ sensor is determined to be working), the entire machine goes in the “mug only” mode until the machine is serviced. If either cup ring performs three consecutive failed attempts with the other cup ring in anti-jackpot timer mode, the entire machine will be in “mug only” mode (assuming PosiVend is working) until the preset time elapses (one more attempt will be made to deliver a cup) or the machine is serviced by a route operator.

6700001 Page - 49 November, 2002